Rocket 22 Sailboat

Description

MODEL DETAILS
– Rocket 22 Sailboat.
– Built in 2007
– Hull Number #11- Hull ID number is RBI220110707
LOCATION:
– Columbus, Ohio
– Will consider partial delivery if needed
SAIL INVENTORY:
– 2020- Ullman Mainsail (Higher aspect shape sails great!)- 2020- Ullman Jib – Carbon Flex LS (110%) ($2500)- 2013- Doyle jib (100%) – 2009- Doyle mainsail – 2009- Doyle jib (110%) – 2009- Doyle 70 series Asymmetrical (Lt. air reacher)- 2009- Doyle 110 series Asymmetrical (Fuller cut, really moves the boat deeper)
EQUIPMENT:
– New Black Mainsail cover 2021- New Black Jib sock 2021- New extra carbon fibre boom- Carbon Mast- Carbon Tiller- Carbon Asymmetrical Spin Pole- TackTick wireless system- Display unit – Compass, timer and start-line bias- Mounted transducer – Speed, depth and temp. – Wired hull transmitter – Wirelessly sends data to the display unit- Solar Panel- Solar Power Regulator- 2 12v Batteries- Padded lifelines- Interior LED cabin light- LED Nav Lights- Keel raising/lowering system- Custom boat cover (In rough shape, but it works for storage) – Various ratchet straps and padding for trailering- 2- sliding hatches (One for keel up and another for keel down)- Boat Hook- Loos Gauge- Spinnaker Launching Bag- Keel Lift
MOTOR:
– Tohatsu Outboard- 2017- 4 stroke- 3.5 horsepower – Tohatsu long shaft
TRAILER:
– 2007 – Road Runner- Surge brakes- Custom bunks- LED Lighting- Bearing Buddies
KNOWN ISSUES:
Boat is in overall very good shape for its age, but it does have a few dings here and there. I tried to be honest about these spots and there are photos for clarification. – 2 inch small repair on deck that is slightly discolored but not a structural issue. This was done prior to me.- There are a couple of chips in the gelcoat on the hatch that covers the onboard cooler- Bottom spreaders were replaced with aluminum. Tops are original and I have a set of aluminum to replace them if needed. – The bottom 18″ of the sail track was removed because when Cunningham applied, the load pulled just enough back to continually separated the track from the mast. I was concerned it might someday unzip the whole mast track from the mast, so removed it and I now use a Velcro strap to keep the sail tight to the mast.- On my list for this winter is to re-caulk where the deck meets the hull. Nothing structural, more cosmetic. – Painted at the waterline with VC17. (2021) – Not necessarily an issue, but wanted to note it
MORE INFO
https://www.facebook.com/groups/1233054130084559https://www.sailmagazine.com/boats/rocket-22https://sailboatdata.com/sailboat/rocket-22